Twitter | Pretraživanje | |
Cory G Watson 28. sij
This weekend I built a keyboard! It's a Tofu65 case and KBD67v2 PCB. It's not a hotswap, so soldering the switches and such is required. Keycaps are GMK Metropolis. Here's the finished product:
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson 28. sij
Odgovor korisniku/ci @gphat
The switches are C3 Tangerines, light green stem. It's a 62g smooth, linear switch. I opted to not lube them because I don't have a switch opener yet and because they say they are smooth. Also they are orange af.
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson 28. sij
Odgovor korisniku/ci @gphat
Here's the spread. I used PTFE lube on the stabilizers along with dielectric grease for the wires. I used bandaids to soften the bottom out after clipping off the little feet in each stab. They are Cherry clip-ons.
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson 28. sij
Odgovor korisniku/ci @gphat
Be sure and test-fit the bottom row! I had some minor misalignment that I caught before soldering. But missed some stuff on the return key.
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson 28. sij
Odgovor korisniku/ci @gphat
Upon adding key caps I realized that the foot of a stabilizer had wiggled loose. I had to desolder 1/3rd of the switches so I could pull the plate up enough to reposition. I was cursing heavily here.
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson
Then after losing a bunch of tiny screws we finished. Same shot as opening tweet of the finished board, other pic is one I didn't have a tweet for.
Reply Retweet Označi sa "sviđa mi se" More
Yann Ramin 28. sij
Odgovor korisniku/ci @gphat
Not doing ergo splits?
Reply Retweet Označi sa "sviđa mi se"
Cory G Watson 28. sij
Odgovor korisniku/ci @theatrus
Nah, I got free of ergo a few years ago and haven't looked back. Also they are all pretty ugly outside of the Ergodox imo.
Reply Retweet Označi sa "sviđa mi se"